Insulated Pipe Riser Clamps for Downward Loads – E1200

Download PDF

a. If thrust plate thickness “B” is greater than pipe wall thickness, consult factory.

b. One pair thrust plates supplied loose for field welding, top only.

Note: For higher load ratings, see: E1300.

All pipe sizes
Easy Installation
Positive stop – axially downward.
May be supported from below or above.
Overlapping galvanized sheet metal jacket
Insulating structural inserts for load transfer
Other I.D.’s and/or O.D.’s available on request
Eliminates condensation sweating on chilled water risers

Performance Test Results on File: Available upon request.

E1200 – E1230 : Applicable PSI spec. doc.: No. 206
Steel Top Thrust Plates
Model E1200: A25 Carbon-Steel
Model E1210: A387 Gr.11 Chrome-Moly
Model E1220: A515 Gr.70 Carbon Silicon
Model E1230: A304L Stainless Steel
Insulation: Calcium Silicate – Asbestos-free, treated with a water repellant.
Jackets: Galvanized Steel ASTM-527
Glue: Industrial contact adhesive
Structural Inserts: High-density calcium silicate asbestos-free, treated with water repellant.
Steel Straps: Carbon Steel ASTM A-36
Fasteners: ASTM A-307 Plated
Coating: Primer coated or hot dipped galvanized. Other coatings available upon request.

Formal Submittal Sheets Available

Model E1200 through E1230 is designed for use on:

• Cold Water
• Hot Water
• Dual Temperature
• Chilled Water
• Vacuum
• Steam
• Gas
• Air

Intended for Installation on:

• Vertical runs of insulated pipe with downward load only.

Other:

• For handling both upward and downward loads, see E2200

Temperature Range:

• Standard: +40°F to +1200°F CalSil Insulation
  Note: Up to 1800°F available upon request.
• Cryogenic: -275°F to +275°F Urethane Insulation.
  Add U after the model number (i.e., E1200U)